loose Boom Bolt

Status
Not open for further replies.
Feb 7, 2005
21
Oday 222 Riverside , New Jersey
I'm preparing to step my mast for the first time on my , new to me , O'day 222 and I noticed that the bolt on the aft end of the boom that secures the aft tang has about 1/4 inch slop in it. I tried to put presure on what I assume is a nut on the inside of the boom and tried to tighten it, with no luck. The only way to excess this "nut" is to drill out the two rivets and pull off the end plate. Is this something I should consider or can I live with this "slop"?
 
Jun 9, 2004
18
Oday 23 DeKalb, Il.
loose tang

that is the way it was set up to be. The main sheet connects to that tang. The bolt is a shoulder bolt.
 
Jun 2, 2004
1,438
Oday 25 pittsburgh
The shoulder that Harley

is talking about allows the piece it connects to rotate. It is meant to be that way as harley has said however, it is for the topping lift not the main sheet. r.w.landau
 
D

Dave

Used for Mainsheet

Kurt, Actually Harley is correct on this one. It is intended for the mainsheet. The topping lift, which, as designed for the 222, is a pigtail off of the backstay, attaches to an eyestrap on the top of the boom. Both are correct that this is supposed to swivel. Dave s/v Hakuna Matatta O'Day 222
 
Jun 2, 2004
1,438
Oday 25 pittsburgh
Sorry, my mistake...

I thought we were talking the O'Day 240. As always still learning to read. That is the model post. Yes the 222 is mainsheeted from the back of the boom. r.w.landau
 
Feb 7, 2005
21
Oday 222 Riverside , New Jersey
Thanks

Gentleman, Thank you for your responce. Being new to the sport it's comforting knowing there's a active forum that can help with those little question that would probably keep me up a night.
 
Status
Not open for further replies.