I've just moved aboard my "new to me" Cabot 36 and starting to do a refit. I'm docked near Jacksonville Beach which puts a lot of the services I see in the Ortega River / Green Cove Springs area out of reach. Currently I'm looking for a rigger to tune the standing rig and give some suggestions on the best way to set up the running rig (I'm trying to figure out the best way to run most of the lines back to the cockpit). I'm also looking for someone to do some sail repairs/replacements. I have a long list of "down the road" projects but since I'm new to the area I don't have contacts like I would back on the West Coast. Any guidance to contractors/service providers in the area would be appreciated.
Jacksonville Beach Services - Rigger and Sailmaker
- Thread starter dwedeking
- Start date
Haven't lived at Jax Bch in years. Built my trimaran on the island under the Atlantic Blvd high rise bridge.
Best I can suggest, from this distance away (time and miles) is ask at the marinas at the Beach Blvd bridge. Used to be two, one each side of ICW
Best I can suggest, from this distance away (time and miles) is ask at the marinas at the Beach Blvd bridge. Used to be two, one each side of ICW
TSBB & SFS
Thanks for the replies. Yea, my fall back position was to go ask up at the marina office but was looking for some personal recommendations. I checked out active captain with little success without going down to the St Augustine area. I'll keep reaching out, thanks.
Thanks for the replies. Yea, my fall back position was to go ask up at the marina office but was looking for some personal recommendations. I checked out active captain with little success without going down to the St Augustine area. I'll keep reaching out, thanks.
