Ideal routing of jib sheet
- Thread starter Project_Mayhem
- Start date
I’d route it inside the lifelines, straight from the block to the clew. It might rub on the lifeline a bit on deeper reaches, but the sheet will be under much less tension then than on a beat. If it really doesn’t work well on deeper wind angles you could have it from block to clew going upwind, and use a separate reaching sheet for deeper angles, but I don’t think that’ll be needed much.
Rare in a discussion about sailing a consensus is emerging.
Route inside the life lines, not through them.
Route inside the life lines, not through them.
Catalina 30 Groups Link
Subscribe at the web forum:
Catalina30 groups.io Group
*All things Catalina 30 and 309! Sponsored by the International Catalina 30 Assn IC30A. FAQs, Q&A, comments, and experiences especially fixes and modifications invited. Share with over 2200 other owners. Website catalina30.com* *Please join the International Catalina 30 Association.
or by sending an email to:
Catalina30+subscribe@groups.io
This comes from this sbo thread by weekendrken:
1992 Catalina 30
Also: www.catalina30.com
***********************************************************
Almost all Catalina masthead rigged boats with only inboard tracks get the jib sheets routed inboard. Has been this way since the C22 and C30s started production in the early 1970s.
You should have a manual for your boat, you've been here long enough to be able to access one.
Good luck have fun rebedding your stanchion bases.
Subscribe at the web forum:
Catalina30 groups.io Group
*All things Catalina 30 and 309! Sponsored by the International Catalina 30 Assn IC30A. FAQs, Q&A, comments, and experiences especially fixes and modifications invited. Share with over 2200 other owners. Website catalina30.com* *Please join the International Catalina 30 Association.
or by sending an email to:
Catalina30+subscribe@groups.io
This comes from this sbo thread by weekendrken:
1992 Catalina 30
Also: www.catalina30.com
***********************************************************
Almost all Catalina masthead rigged boats with only inboard tracks get the jib sheets routed inboard. Has been this way since the C22 and C30s started production in the early 1970s.
You should have a manual for your boat, you've been here long enough to be able to access one.
Good luck have fun rebedding your stanchion bases.
Your Catalina has inboard shrouds which facilitate tighter sheeting angles.
Pull your fenders on deck when sailing.
Don't hang fenders from lifelines, see it making your slack lifeline jump up and down. It's taking a load then releasing, using the stanchion as a lever. Tie fenders to the base of stanchions so they aren't stressing them wrong way over and over 24/7.
Pull your fenders on deck when sailing.
Don't hang fenders from lifelines, see it making your slack lifeline jump up and down. It's taking a load then releasing, using the stanchion as a lever. Tie fenders to the base of stanchions so they aren't stressing them wrong way over and over 24/7.