Hunter 260 Electric Conduit in Ceiling

[rs1sensen]

Where does the conduit for the VHF that starts near the compression post come out? I’ve been hunting behind the DC panel and can’t find it. Trying to run a cable for a new Raymarine Wind Meter with a ST60+ monitor that I got new in box for $200!

I opened all the access ports up around the stove area and tried peaking around in the ceiling with my phone camera. I was hoping to use the conduit as there is a feeder line pre-installed in it but if I can't find the other end it doesn't help. I opened up all the access ports and the DC panel. Will likely end up just having to fish line the best I can.

 

[Ralph Johnstone]

Will likely end up just having to fish line the best I can.

Which is exactly what I did for the new wind sensor. All you will find (at least with mine) is a single cable carrying the VHF signal and impossible to locate.

 

[Crazy Dave Condon]

Where is the VHF located. Is there an inspection port inside the boat in the ceiling starboard side of the mast? Does the VHF cable goes through any fittings topside on the deck and if so picture please. Once I get answers to my questions along with photos, I can better advise

 

[Crazy Dave Condon]

Looking at my last response, as a dealer, I was involved with the design of the boat plus I sold nearly 20-25% of the production line which is why I know it too well. Questions I ask would determine what I would suggest to do

 

[rs1sensen]

Looking at my last response, as a dealer, I was involved with the design of the boat plus I sold nearly 20-25% of the production line which is why I know it too well. Questions I ask would determine what I would suggest to do

Hey Dave - I've been under the weather sick for a couple days but will be back on the boat this weekend and will follow up.

 

[Crazy Dave Condon]

Ok