Can anyone help with some pictures of the factory installed spinnaker gear set up. Particularly the forestay and how they installed the spinnaker halyard block and what block to use. Also anything on the lines, turning blocks and sheet stopper. What size spinnaker pole? Mast eye connection.
Hunter 23.5 Spinnaker Gear
- Thread starter charlieyacht
- Start date
- Status
rig a spinnker
you don't have to use factory method use a tweeker system 8 smally pullys and 4 cam cleats get the small adjustable spin pole 6' to 10' and 6' of track at the front of ya mast w/2 eyes that also gives a sto spot for the pole . mount one set pullys mid ship lines run with pullys on end thru and up to 2 others to direct to cockpit cam cleats spin lines run from spin feet thru tweek pully to stern pully to cam cleat at stern picts when I get to boat
you don't have to use factory method use a tweeker system 8 smally pullys and 4 cam cleats get the small adjustable spin pole 6' to 10' and 6' of track at the front of ya mast w/2 eyes that also gives a sto spot for the pole . mount one set pullys mid ship lines run with pullys on end thru and up to 2 others to direct to cockpit cam cleats spin lines run from spin feet thru tweek pully to stern pully to cam cleat at stern picts when I get to boat
Thanks, I'll be interested to see the pics. The jib on my boat is roller furling so I was planning to use the jib halyard as the pole topping lift. So it's a matter of rigging a foreguy and some turning blocks by the aft mooring cleats. The one that I'd like some help with is the way they installed the spinnaker halyard block. For our Z-Spar mast there is a combination jib halyard, forestay and spinnaker halyard fitting which Hunter didn't use. So it looks like what they offered was an exit block just like the jib halyard block but mounted over the forestay about the same relative location as the jib halyard block below. Just wanted to see how they did it.
- Status