Hatch Cover repair

Status
Not open for further replies.
B

Bill11554

.
May 8, 2005
17
- - South Lake Tahoe, Ca
I was in a car wreck September of 04 so after two winters of snow load, I was finally able to un bag my oday 20. My sliding hatch broke where the mast was laying across it. It looks like the plywood core has seperated inside and about half the front edge has broken off. 1} Is it an easy repair? 2) How do I take the teak slide rails off? 3} Is there a place I can get a replacement? (emailed D & R - no response) 4) Should I just bulid a new one out of teak? Thanks for your help Bill odaytahoe20@aol.com
 
J

Jack Hart

Call Rudy at D&R.

Howdy, you should call Rudy and talk to him direct. He is not keen on e-mail for some reason, however he is super helpful when you call him on the phone. Hope that helps. Jack
 
M

Mike

Rudy's phone number

Rudy's phone number at D&R marine is: 508-644-3001 office 508-644-3002 fax D&R has a web site; drmarine.com. The phone number and lots of other information is there too. Good luck on your project. Mike
 
B

Bill11554

.
May 8, 2005
17
- - South Lake Tahoe, Ca
curious

I talked to Rudy. He has a mold for a 22 sliding hatch. Does anyone know offhand if the 20 and the 22 have the same size sliding hatches?
 
M

Mike

didn't Rudy know?

Didn't Rudy know if the hatch sizes for the 20 and 22 are the same size? Seems like he ought to know. Mike
 
B

Bill11554

.
May 8, 2005
17
- - South Lake Tahoe, Ca
No

He did not, I am going out in the next couple of days to take all of the measurements and call him back. I was curious if anyone knew offhand
 
Status
Not open for further replies.

Top Bottom