D
Doug
Hi Gorden, I wrote a previous article to you at the start of this forum and you were right on. I had a vibration at certain rpm's on my 3HMF and I've done all new mounts etc. all by the book. But you said to make sure all the mounts were equally weighted, and sure enough one of them was not. I evened out the weight on all 4 then realigned and it's perfect now thank you. I now have just found a new problem I have fuel comming out from the intake manifold seal. Is this just because the seal went bad? Or would I have another problem? I personally would think that if this seal is bad it should just suck air not leak fuel. But after some running time she is wet around the manifold, and a couple drips to the bilge pan. But she continues to run just fine, no smoke at anytime, and no running conditions noted. Your response is very much appreciated.ThanksDoug