A little bit of background information. The first prompt I received was Low Voltage. The batteries were in good order. When I went to reset the breaker, then I got no power. So ordered a new breaker.
Then while sailing, we had an electrical fire. (A whole different story) Batteries were replaced as were the 60 amp fuse. Okay, problem solved? No. then I got the reading Mixer Motor Overload
I did take the Electra Scan apart and did find a little bit of foreign matter, as directed by the manual. Cleaned it, put it back together, and tried to run it again and got the same prompt. So I have several questions.
1. Did the electrical fire create a surge that may have fried the motor?
2. Do I need to take it apart again and possibly remove the motor to inspect any hidden debris?
3. Do I need to replace the motor?
Then while sailing, we had an electrical fire. (A whole different story) Batteries were replaced as were the 60 amp fuse. Okay, problem solved? No. then I got the reading Mixer Motor Overload
I did take the Electra Scan apart and did find a little bit of foreign matter, as directed by the manual. Cleaned it, put it back together, and tried to run it again and got the same prompt. So I have several questions.
1. Did the electrical fire create a surge that may have fried the motor?
2. Do I need to take it apart again and possibly remove the motor to inspect any hidden debris?
3. Do I need to replace the motor?
