Edson wheel Clutch and Throttle Control (H260)

[pfchenier]

I just installed a guard railing in front of my Edson wheel ; I have the Standard Clutch and Throttle Control installed but now the controls are limited in movement by the guard ; Is it just a matter of adjusting the cables lenght to make the controls working ?
thanks,
Pierre

 

[soling42]

I have the same setup on my '04 h260 and I simply did as you assumed you'd need to do, Adjust the throw of the throttle to operate the cable at a proper range. The shift lever is mounted astern of the pedestal and shouldn't be an issue. Getting down inside the pedestal is a nightmare so I hope it goes well.

Great addition, can't imagine an Edson pedestal without one.
Mike

 

[pfchenier]

thanks Mike, simpler than I tought it would be ; always learning!
Pierre