I've checked through the archives and haven't found this answer. I hope someone here can help. I recently purchased a Cherubini 1981 27'. A roller furling had been added but rather than modify the bow pulput or the furling attachment to fit properly, the furling was attached farther back on the bow. This has caused some lifting on plate in which it's attached. On top of that, the bow pulpit must have been in an accident since it is bent. Yesterday I took the bow pulpit off and took it to the welder. I neglected to mark any measurements from the boat. Didn't realize my mistake until I was at the welders and you really can't tell which posts need adjusting. Can someone provide me with the following measurements; between the 2 front posts, between the 2 back posts, and the measurement between the front and back post? Unfortunately, the boat currently is 100 miles from me and not an easy trip through downtown Chicago traffic. Hopefully, I'll be bringing it down soon to be closer to me, What I should have done, got the hint from Dan's archive post, was to make a template of the bow of the boat along with the post attachment holes. Ahhh, hind sight!