cutlass bearing

[mopieo8]

Does anyone know what dimensions of cutlass bearing fits a newport 30 mk2?
Also, does anyone know the stern tube dimensions?
Pulling the boat next week and would like to have parts first... dreamer...

 

[CalebD]

There are only 3 possible sizes of standard Cutless bearing for a 7/8" shaft. The only dimension that is a variable is the Outer diameter of the bearing: 1-1/4", 1-3/8", 1-1/2".
Measure carefully before ordering.

http://www.deepblueyachtsupply.com/marine-bearings/naval-brass-inch-cutless-bearings

 

[mopieo8]

Thank you kind sir!
Do you think I can pull the shaft coupling and replace without destroying the shaft? The closest boat lift (by far!) is on a remote island!
I'm going to bring all three sizes of cutlass bearing and return two of them.

 

[Windborne]

Hope this isn't too late for you. These are the sizes off of my 30MKIII.
shaft 7/8 od
log 1-5/8 od
cutlass bearing 7/8x1-1/4

Len Keller
Windborne
Madeira Beach, FL
On Florida's Left Coast

 

[mopieo8]

thanks!

Thanks everyone!
I dragged my boat into the bank of a sandy warm river and went for a swim with some calipers. 1 1/4 was what I came up with. Thanks for confirming!