Recently I upgraded our house batteries to 2) 6v batteries with 245 ah capacity, in addition to my group 27 starting battery with 105 ah. We are on a mooring, so we get limited engine run time, and limited shore power to run the charger. Our boat had the original 1983 shore power charger, and when the house battery died halfway through the season ( it had tested good a few weeks earlier) I suspected a problem with the charger - it had been acting somewhat erratic earlier. I am in the process of installing a new Trucharge 20, but this weekend we motorsailed for about 4 hours on our way back from a trip. Even with 4 hours of engine run time, the batteries were not charged sufficiently. I pulled the alternator and had it rebuilt - the diodes were shot. Upon reinstalling the alternator, I am still only getting 12.4 volts at the batteries (same as before the rebuild), even though I have 13.7 at the output of the alternator. I am not sure what would cause such a voltage drop - any ideas where to start looking? The alternator is the stock 55 amp Motorola.Thanks,Scott