R
Rick Engel
Lask week, we had a frightening experience. While our Hunter 26 was moored in its slip, my wife & I rambled down the dock to visit with some friends. In the meantime, our 13 year old daughter invited several of her dock pals into our boat for a game of cards. We knew they were at our boat, and approximately one hour later, I checked in on them to give a friendly 15-minute "time to leave" signal.However, to my dismay, the floor (under the companionway), was covered with water. After shuffling out the kids, we quickly found the manual bilge pump & removed approximately 25 gallons of water. The water had not significantly run to the stern, & therefore the electric pump was of no assistance. As soon as we got this water out of the boat, it eventually became apparent that the leak had stopped. Not surprisingly, I slept with my hand on the floor inspection cap! The next day, we reloaded the boat with friends, & discovered the water was seeping in from the centerboard housing unit. On top of this area, there is a plate with a large nut that attaches to the centerboard. Last year, a repairman helped us pull the keel to replace the lifting rope. Although he sealed the inspection plate, it became obvious that he did not seal the lower metal plate to the fiberglass housing unit.I checked the archives of this forum, & the concensus appears to be that this plate must be heavily gooped with 5200 sealant. That is what we have done, & I am desperately hoping that when it cures, we will have fixed our problem. I once read a negligence case out of Chicago. A family lost a couple of kids because a sailboat with a swing keel was overloaded & sank before the kids could be removed from the cabin. At the time, I never dreamt this could happen to a Hunter.Am I paranoid or do others suspect the Hunter centerboard boats can be overloaded?Thanks,Rick Engel