Catalina windows
- Thread starter Lost Parent
- Start date
- Status
Without telling us what it is you are doing, it is very, very hard to help you.
What specifically is it that you are doing, step-by-step.
Attach files, Upload files here button, upload pictures, find file from browse button, click.
Right?
What specifically is it that you are doing, step-by-step.
Attach files, Upload files here button, upload pictures, find file from browse button, click.
Right?
You've done it successfully before, right? So you know how to upload them, I think. (If not let me know!) If so, and you're getting an error message, make sure the image files are jpegs and that they're of some reasonable size. If they're over one megabyte they will need to be reduced.
Ok now that the pictures are up, what was the point? 
Because I have a boat load of questions.
What did you use to seal and mount the windows?
How did you hold them in place while it cured?
Were your window openings indented or flush with the cabin surface?
How did you cut the acrylic?
Did you bevel the edges with a router or by hand tool?
How are you trimming the inside edge of the fiberglass?
BTW: The windows look great.
Because I have a boat load of questions.
What did you use to seal and mount the windows?
How did you hold them in place while it cured?
Were your window openings indented or flush with the cabin surface?
How did you cut the acrylic?
Did you bevel the edges with a router or by hand tool?
How are you trimming the inside edge of the fiberglass?
BTW: The windows look great.
Yu have'nt seen nothing yet we have not taken the paper off this side and you only see open holes except for the one window
Dow corning 795 black
Held for 30 seconds even on a curved cabin
they had no indentations around windows ..surface mount
I purchased the windows from Cruising concepts and they are great , inside frames and all
Thanks we are impressed with the look
Dow corning 795 black
Held for 30 seconds even on a curved cabin
they had no indentations around windows ..surface mount
I purchased the windows from Cruising concepts and they are great , inside frames and all
Thanks we are impressed with the look
So the 795 cured in 30 seconds? Wow. I read some where that it was recommended to drill holes for screws to hold the windows in place waiting for the cure, then remove screws and fill holes with silicone. I new there had to be a better way.
Better living through chemistry.
Congratulations on a beautiful job.
Better living through chemistry.
Congratulations on a beautiful job.
- Status