My holding tank gauge on my Hunter 376 always registers empty and my fresh water tank gauge always registers full...both are broken. Is this a common problem and does anybody have any advise on how to fix them, especially the holding tank gauge?
Broken holding tank gauge
- Thread starter Brandon9402
- Start date
- Status
I have same problem
Brandon, I bought my Hunter 376 (new) in '97 and started to experience the same problem you have described within a couple of years. I have pulled the sensing units - not a pleasant job on the waste tank -- cleaned everything up, put them back in (and modified the gasket and attachment bolts - but that's another story). They worked for a while then did the same thing. I have given up. Today I just estimate when I will need a pump out or water fill. This method has worked for me. If I decide to install new gages they will definitely not be Wema's - product is totally unreliable and useless in my opinion. Ken
Brandon, I bought my Hunter 376 (new) in '97 and started to experience the same problem you have described within a couple of years. I have pulled the sensing units - not a pleasant job on the waste tank -- cleaned everything up, put them back in (and modified the gasket and attachment bolts - but that's another story). They worked for a while then did the same thing. I have given up. Today I just estimate when I will need a pump out or water fill. This method has worked for me. If I decide to install new gages they will definitely not be Wema's - product is totally unreliable and useless in my opinion. Ken
Replace the Wema gauges with one that
has a sender that goes on the outside of the tank. These are the best 'bang for the buck' on the market...best price, best quality, best customer service: http://ferriellosales.com/default.php
has a sender that goes on the outside of the tank. These are the best 'bang for the buck' on the market...best price, best quality, best customer service: http://ferriellosales.com/default.php
- Status