Hi All: I'm removing and replacing my 1994 H26 bow pulpit and a forward port stanchion that was damaged during Tropical Storm Cindy. Any advice on removing the old and installing the new pulpit and stanchion would be greatly appreciated. Also, info on how they're installed would be helpful. Do the mounting screws go through embedded & threaded backing plates or are the backing plates on the inside surface of the fiberglass and fastenecd with bolts? When I tested a couple of the large philips head mounting screws, they were very tight and I want to make sure I don't "bugger" them up if I have to use some force. Any advice on screw removal of "stuck" screws? The fiberglass surrounding the pulpit and stachion mounting doesn't appear to be damaged but if anyone could tell me what not-so-obvious damage to look for would be helpful. Any info and advice would be greatly appreciated. Thanks, Brian