Block glassed onto hull

C

chris brown

.
Mar 6, 2012
53
I am installing a new head. Since the old mounting board plate is somewhat
cut up, I decided to replace it. When I removed the old board, I noticed a
block of wood (I guess) about 3X5 inches X .75 inch thick (7X12X2 CM I
guess) thick glassed onto the hull. I can see no use for this, unless it is
meant for some kind of backing plate for a transducer (which this one
doesn¹t have). What is it for? Any reason to leave it in place?

Thanks,

Chris Brown


[Non-text portions of this message have been removed]
 
F

fotofundi

.
Oct 30, 2019
80
I have a similar block glassed onto the inside of the hull. Don't know
the original purpose but I have an electric water pump attached to mine
that feeds fresh water from the holding tank to the sink. Maybe it was
an optional accessory?

David
V1696
 
B

bv0820

.
Jun 24, 2003
66
Bock is for mounitng a foot pumb for the sink area in the head. Same function as below sink in the galley

Bob Vogel
Laughing Gull #1877

David Runyard dr@... wrote:
I have a similar block glassed onto the inside of the hull. Don't know
the original purpose but I have an electric water pump attached to mine
that feeds fresh water from the holding tank to the sink. Maybe it was
an optional accessory?

David
V1696
 
You must log in or register to reply here.

Top Bottom