Beneteau 43 line layout

Status
Not open for further replies.
Jun 6, 2004
30
Beneteau 43 Milford, CT
I have a 2008 B43 that I need the line layout from the mast. Not sure if they is a standard way to string them. From the mast which pulleys and such. If anyone has a pic, that would be great.

Thanks
 
Nov 24, 2012
586
Are you asking about the layout of the halyards etc? Two good sources - spar manufacturer and the rigging diagram in your manual.
 
Mar 19, 2013
75
Beneteau First 38 Chicago
Wouldn't it be great if Beneteau made manuals available for their boats? It shouldn't be that dificult.
 
Jun 4, 2004
57
- - DFW
There really is no "standard" way to run the halyards. Beneteau typically runs the main and jib halyards to the port side of the boat if they are only installing deck organizers on that side. The jib would ordinarily exit higher on the mast to facilitate "jumping" it. Once out of the mast, run them through the turning blocks, deck organizer and then clutches in the manner that provides the freest run, preferably without any crossing.

If you are going to race or just want to set up like the race boats, then the jib and spinnaker halyards generally exit the mast to starboard. This is generally done to facilitate hoisting frequently changed sails from the high side of the boat while rounding marks. The main can go to either side since it is not changed during a race. Other control lines can be led in the most efficient manner for your boat and crew. Again, once they exit the mast and get to the turning blocks, the most free run possible is best.

On my boat, if you are interested, I have the lines run as follows:

Port side (from left to right) - jib hal, spin tack, main reef, main hal, vang

Starboard side (from left to right) - mainsheet, cunningham, outhaul, spin hal

I don't race, but typically launch the spin to port, hence the halyard on starboard.
 
Mar 19, 2013
75
Beneteau First 38 Chicago
Yep, forgot about that Beneteau site...not a lot of detailed information about systems in the manuals. I'm used to referencing my specific car repair manuals I suppose.
 
Jun 6, 2004
30
Beneteau 43 Milford, CT
Thanks for the help.

I appreciate the feedback. Should be good to go now.
 
Status
Not open for further replies.