Ok so I have a 2002 Hunter 356. I have done all upgrades myself over the years. From engine disassembly to refrigeration install, etc. Today since we re stuck in a WI slip for 1 more day I thought this is the best time to install my long awaited battery system monitor gage. I want it to be located at the nav station of course. And of corse the batteries are in the deep locker in the cockpit with the head / vanity compartment between them. So I proceeded to drop down the main dc panel at the nav station and then removed all trim around the 1st port light to facilitate removing the big plastic garnish panel that ties into the soft vinyl ceiling panels. This would permit clear access for my fish tape to pull conductors between the battery bank and the area I wanted to mount the new gauges in. The problem is I cannot remove the garnish panel from the vinyl roof sections. I’m not sure if it snaps off or what. I did not want to break it. If anyone out there has done this procedure before I’m all ears thank you.