F
Frank LaBrake
The Jabsco manual toilet on our boat has three 3/4" hoses connected to the pump. The floor-level hose appears to be the inlet line that runs to a second hose at the top of the pump that runs to the bowl at the back. The third 3/4" hose runs through a locker to a vented loop and then back through the boat to where the holding tank is located.The pump pulls water into the bowl when switched to the wet position and when pumping in the dry position the bowl empties (if pumping continues in the wet position the fresh water continues on out of the system to the holding tank).My problem -- On many occasions the pump develops back pressure during the dry position pumping and you can see the third 3/4" hose that runs to the vented loop appears stressed with this pressure. This happens regardless of the level in the holding tank. This is our second season with the system and I don't recall experiencing this at all last season.Any suggestions on cause and cure? Thanks for any help you can offer. The Jabsco literature doesn't say anything regarding troubleshooting.