I have couple of questions regarding this topic.
I want add separate 30 amp shore power inlet to feed my new installed 16l BTU Webasto FCF AC unit.
So after 30 amp inlet I an installing ELCI Main 30A Double Pole breaker. Green wire after inlet going directly to galvanic isolator and then where the green going?
And second set of questions after I install metal components of AC system, that contact with sea water, like through-hull, unit it self, sea strainer (also bronze in the webasto installation kit) how I understand I need to bond them. So I am bonding them to existing boat ground bus bar, or I have to create new ground bus bus using my green wire going from isolator. I think green after isolator have to meet with DC ground and that point
I want add separate 30 amp shore power inlet to feed my new installed 16l BTU Webasto FCF AC unit.
So after 30 amp inlet I an installing ELCI Main 30A Double Pole breaker. Green wire after inlet going directly to galvanic isolator and then where the green going?
And second set of questions after I install metal components of AC system, that contact with sea water, like through-hull, unit it self, sea strainer (also bronze in the webasto installation kit) how I understand I need to bond them. So I am bonding them to existing boat ground bus bar, or I have to create new ground bus bus using my green wire going from isolator. I think green after isolator have to meet with DC ground and that point
