Last fall i had the cooling hose that feeds into the elbow crack and peed water around the engine compartment. Seems a casualty of this was that the throttle cable connects to a lever on the engine block-that lever is frozen and a bit rusty. Before I left the boat yesterday, I shot the lever up with PB Blaster. I hope it frees it up. So my question- if I gotta replace this lever, how much of an undoing am I in for????
I figure I can disconnect and buff it out of any superficial rust and repaint. Anyone have this issue? I am concerned if I try loosen the hex bolt pivot on that lever something inside may drop '<
I figure I can disconnect and buff it out of any superficial rust and repaint. Anyone have this issue? I am concerned if I try loosen the hex bolt pivot on that lever something inside may drop '<