so last weekend I was changing an outlet. When I put the power back on to test I inadvertently hit the ground wire instead of the common. Popped the gfi feed leading to boat (15p). I climbed down and reset then checked outlet and all is well. Tested gfi and all worked properly. However......... (of course) now my voltage display that shows the 110 to panel after flipping main breaker is always showing voltage..... main breaker on or off. However when In off position no power is being fed to panels as it should be.... when main breaker is on all work well. I pulled display (with main breaker off but still plugged in) And disconnected common wire and needle went to 0 as it should so display seems ok. So what did I blow? Figure I will open panel up today to see if I can see anything..... any ideas......
Thanks
Greg
Thanks
Greg