working on the pulpit area.
Disaster! The epoxy bled through the paint on the bulkheads. The paint is so soft it can be scraped with fingernails. the yellow blush is "Amine blush". I should have cleaned the cured epoxly with a sponge and water before applying the pant. NOw I have to make and finish the bulkheads all over again......
The area under the mast ready for final sanding and paint. I repaired the core using usual the usual technique for cored deck repair but added a small elevation where the mast plate attaches.
preparing to remove the two speed winch, drum is removed. I will take this oportunity to service them.
working on the pulpit area.
I later decided to go with full sized bulkheads (so far) and this is when i sealed them with three coats of epoxy. Subseqently I painted them with off-white polyurethane.
The most controversial move yet. i will enlarge the vbirth, eliminating the forward head, and sink, and shrink the bulkheads, but reinforce with larger compression post. (advised that this compromises integrety, i later went with the original floor plan. plus my wife didn't want to give up the private head!)
the tabernacle area cut out
emergpa1

working on the pulpit area.

There are no comments to display.

Media information

Album
The rebuild Oday 26
Added by
emergpa1
Date added
View count
396
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
4718-1243449185-44eba010902615a7260ae2369ae90652.jpg
File size
43.9 KB
Dimensions
600px x 450px

Share this media

Top Bottom