The area under the mast ready for final sanding and paint. I repaired the core using usual the usual technique for cored deck repair but added a small elevation where the mast plate attaches.
I installed NewFoundMetals Trimatrix ports. The ports have a rubber gasket and do not need sealent. So far the only trouble i have had is getting the adjustment right on the latches. So far no leaks
new forward hatch and trimatrix ports installed, also shows repaired area of mast and chainplates. Note that i elevated the areas of attachment to try to decrease tendency to leak. Paint matches ok. Maybe i should have tried to use gelcoat.
Disaster! The epoxy bled through the paint on the bulkheads. The paint is so soft it can be scraped with fingernails. the yellow blush is "Amine blush". I should have cleaned the cured epoxly with a sponge and water before applying the pant. NOw I have to make and finish the bulkheads all over again......
The area under the mast ready for final sanding and paint. I repaired the core using usual the usual technique for cored deck repair but added a small elevation where the mast plate attaches.
preparing to remove the two speed winch, drum is removed. I will take this oportunity to service them.
working on the pulpit area.
I later decided to go with full sized bulkheads (so far) and this is when i sealed them with three coats of epoxy. Subseqently I painted them with off-white polyurethane.
emergpa1

The area under the mast ready for final sanding and paint. I repaired the core using usual the usual technique for cored deck repair but added a small elevation where the mast plate attaches.

There are no comments to display.

Media information

Album
The rebuild Oday 26
Added by
emergpa1
Date added
View count
451
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
4975-1245337062-44af75cda27912f6208ce9fbdc8e6eaa.jpg
File size
51.5 KB
Dimensions
600px x 450px

Share this media

Top Bottom