I moved the batteries from the starboard area to a plank i mounted athwartships. I attached to the two runners in the hold by tabbing it in with strips of epoxy soaked fiberglass cloth. then used lashing and staps to secure the battery boxes to the board.
My Girl Right after launch!
Finally. Up on the lift getting two coats of Micron CSC bottom paint
I mounted the four stage two bank "reya dolphin" battery charger on the port side of the switch box on the rear bulkhead under the gangway steps.
I moved the batteries from the starboard area to a plank i mounted athwartships. I attached to the two runners in the hold by tabbing it in with strips of epoxy soaked fiberglass cloth. then used lashing and staps to secure the battery boxes to the board.
The main components of my new cabin lights. I used boat cable, brass tone lights, and marine grade heat shrink connectors. I could not afford the LED, but hope to upgrade lamp by lamp as time goes by.
ready to install a footpump in the galley sink. My wife loves it. It is a big improvement over the hand pump that came stock on the boat.
The hatch that D & R sent me for my boat did not fit. It was a mistake from the supplier. After much confusion and wrangling they took it back. I ended up going with the bomar hatch, which still required a modification, but liked the results.
emergpa1

I moved the batteries from the starboard area to a plank i mounted athwartships. I attached to the two runners in the hold by tabbing it in with strips of epoxy soaked fiberglass cloth. then used lashing and staps to secure the battery boxes to the board.

M
Great Idea. I just bought the same boat. Did you make the rack to hang lines on? How did you attach it? thanks
 

Media information

Album
The rebuild Oday 26
Added by
emergpa1
Date added
View count
465
Comment count
1
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
7422-1263005159-97a3093e4c86aeb7789cc30ecdf6b0fb.jpg
File size
48.8 KB
Dimensions
600px x 450px

Share this media

Top Bottom