B & R Rig Tuning

Status
Not open for further replies.
Mark Nooney

Mark Nooney

.
Nov 23, 2011
87
Hunter H31 Kent Island Yacht Club
Hi
I have a H31 with the B & R rig. Is there any information available on the shrouds tension from the chain plates. The previous owner had mentioned
keep an eye on the shrouds but didn't provide tensions on the loos gauge.

Any thoughts?
Thanks
Mark
 
Ralph Johnstone

Ralph Johnstone

.
Jan 4, 2006
7,282
Hunter 310 West Vancouver, B.C.
Tuning a H31 .................

This was sent to me last week by Eddie Breeden of Marlo Hunter for a 306. I had spoken to him about tuning our 310. It's taken from their 306 manual and applies to the 310 as well. It's good as far as it goes but I'm a little like you in that I'd feel better if I had some Loos numbers to go by.
 

Attachments

mellis18

mellis18

.
Nov 9, 2008
57
Hunter 31 Port San Luis, CA
I have an 84 H31 also and have some info on the B&R rigging. I'll try to remember to scan and send tomorrow.
 
Mike Culik

Mike Culik

.
Aug 23, 2011
94
Hunter 31 Georgetown, MD
Mark, my shrouds were loose when I got my H31 also!

As Jared pointed out, the reason was because I found my compression post rotted out at the top and bottom.

That made for a good winter project that has been well documented on this forum.

Great boat and good luck!

Mike

PS Ralph thanks for the great documentation!
 
Mike Culik

Mike Culik

.
Aug 23, 2011
94
Hunter 31 Georgetown, MD
Re: B&R Rigging

Mellis18,

You’re my hero!

I've been looking for the H31 specific manual for awhile...
Have seen plenty of generic pages...

Thank you so much

Mike
 
Status
Not open for further replies.

Top Bottom