Help with water heater install

Status
Not open for further replies.

maxxx

.
Oct 15, 2009
60
oday 28 Ft. Loudon lake
I'm looking for advice on replacing the Raritan round 6 gal water heater on my O28. I'm looking at the square Seaward or Kuuma units with heat exchanger. anybody have any ideas on which might mate up with the current hoses?? any ideas or suggestions will be appreciated. Thanks, max
 
Jun 2, 2004
297
Oday 35 Staten Island, NY
I'm looking for advice on replacing the Raritan round 6 gal water heater on my O28. I'm looking at the square Seaward or Kuuma units with heat exchanger. anybody have any ideas on which might mate up with the current hoses?? any ideas or suggestions will be appreciated. Thanks, max
Max,

I replaced the Atwood H2O heater on my 322 with a Seaward unit. Mating up the hoses was not an issue. I can't be 100% sure, but I would think that there's a certain degree of standardization in this regard (sort of like lightbulb sockets). 1/2" NPT is a pretty standard fitting, as I recall.

BTW, I'm pretty pleased with the performance of the Seaward unit thus far (2 seasons).

Pete
s/v EmmieLou (O-322)
Little Silver, NJ
 

RECESS

.
Dec 20, 2003
1,509
Catalina 27 . St. Mary's Georgia
How long does it take using 120v to heat 6 gallons with one of those?
 
Jun 2, 2004
297
Oday 35 Staten Island, NY
How long does it take using 120v to heat 6 gallons with one of those?
Not very long at all. There were some occasions last season where I was getting ready to clean up supper dishes, and realized I hadn't turned the water heater on after getting back from work. Flip the switch, wait maybe 15-20 minutes tops, and there's enough to get the dishwashing underway.

It might take a little longer to heat the entire tank (say, if you were eager to shower on board), but not too much more, I'd say.

Pete
s/v EmmieLou (O-322)
Little Silver, NJ
 
Status
Not open for further replies.