H49 Bow Thruster

Apr 6, 2004
69
Hunter 49 Downers Grove, IL
Okay, so kind of embarrassed that I don't know this info, but I haven't really had a need to know, until now. We have the 2007 H49, with what I assume was a factory installed MaxPower bow thruster. I don't have a separate battery for it, and have never seen a separate breaker for it in any panel, like I have for the windlass and cabin top winch. End of last season, the helm control died for it. I replaced with a new control (having to realign the wiring to match colors, as MaxPower apparently has changed that in the last 19 years).
Control now powers up, and I swear when I first tried it, the motor ran for a second, but then stopped. I still have power at the controls, and can hear the solenoids get thrown when the buttons are pushed. Props spin freely by hand. Both house and starter banks have over 13v. I was hoping to track down what I assume is a high amp fuse, so I can test that, but have no idea where it is. I have tracked wiring from the bow berth, into the floor of the forward cabin. Harder to trace thru the floor of the main cabin, but there's a 200A fuse in the starter battery compartment that looks like a strong possibility? It tests fine.

I have reached out to MaxPower and they have a few questions for me. My google search indicates either a blown fuse, possibly burnt relay contacts, or a bad control box. ANyone here had similar issues with their MaxPower thruster?
 
Apr 6, 2004
69
Hunter 49 Downers Grove, IL
Was going to delete this, as I effectively found the answer with a bit more digging on board. But figured that I'd share in case anyone else might need the info.

On our boat, that fuse (which is indeed blown on our boat) is in the house battery area, under the salon table. On the starboard side wall of the compartment, there are 3 big 300A Class T fuses, and the bottom one on our boat is for the bow thruster. I have a replacement on hold for me, so as soon as I can get a ride to pick it up and get back to confirm that solves the issue, I'll edit/update this reply with final outcome.

Thanks!
 
Sep 25, 2008
7,749
Alden 50 Sarasota, Florida
A voltmeter and 5 minutes should tell you where the problem is. Check voltage at the thruster motor when you energize the solenoid. If you have 13v there, “voila”. if not, trace back to where you have power
 
Apr 6, 2004
69
Hunter 49 Downers Grove, IL
A voltmeter and 5 minutes should tell you where the problem is. Check voltage at the thruster motor when you energize the solenoid. If you have 13v there, “voila”. if not, trace back to where you have power
Don -

That's effectively what I did. I was obviously getting some power there, the solenoids were tripping when the buttons are pushed. And I was not apparently getting power on the mains, but I wasn't sure if that was to to the control box or the control panel or a bad fuse. Which is why I was looking for some insight on where the fuse was located. Took me a couple of passes trying to trace the run, but was able to get the right floorboards lifted and a camera into the right nooks and crannies to trace the wire. And low and behold, the fuse was blown. Hoping to grab an Uber soon to get it, if this weather will break.

T J