1994 Hunter 40.5. I started to replace the outhaul line on my 40.5, which is looking pretty ratty. The line runs inside the boom and has a set of blocks to increase the purchase but I can't figure out how to replace it. It looks the termination point of the line is on one of the blocks that is fixed inside of the boom rather than the block that can be pulled out the aft end of the boom. Why on earth you'd design it such that you have to remove the boom and the ends to replace this line is beyond me as an engineer. Below is a crude sketch. Does anyone have experience with replacing this line and can it be done without removing the boom and the forward cap.