So today’s agenda is to figure out why my refer and freezer won’t start running this year. It was working fine last year. I’ve checked that it still has 134a in the system and it does. When I turn on the switch’s at the breaker panel the compressors do not run. They are getting power about every 5 seconds or so but just for less than a half second or less. You can hear the compressor try to start and then stop. It acts like maybe it is pulling too much current as my battery monitors voltage drops way down when the compressor tries to start. There is a red LED on the controller that is blinking every 5 seconds or so. I’ve checked all the fuses around the compressors which are all good. The system is an Adler Barbour. Does anybody have any ideas?
