All Activity
-
jssailem replied to the thread Overheat adventure on 1985 Universal M12.It is if you find a friendly Radiator shop...:biggrin: -
jssailem reacted to odaydokay's post in the thread Overheat adventure on 1985 Universal M12 with
Ha.
Slick! -
jssailem replied to the thread USS Constitution Day!!.Happy Birthday, Old Iron Sides (Navy Jim that is).:biggrin::beer:
-
Happy Birthday!! From Navy Jim...
-
jssailem replied to the thread Deck hatches for US-made 2002 Oceanis 311.Have you called Lewmar? I have found their tech staff are very knowledgeable and helpful.
-
jssailem replied to the thread Replacing the cutlass bearing on a 1996 Beneteau 351.Ok. You have one that is mounted in the keel. Same design as I have on my boat. You should be able to pull the prop. Then slip the old...
-
Kkeven replied to the thread Replacing the cutlass bearing on a 1996 Beneteau 351.Attached a photo of the top of the cutlass bearing, the rest im hoping to pull out after I’ve removed the shaft. Thanks in advance for...
-
-
jssailem replied to the thread Hunter 260 and Use of a Jack Plate to Support the Motor.Not sure about a "Jack Plate", but they make motor mounts that raise the motor vertically to get the prop out of the water...
-
-
ToddL214 replied to the thread Starboard Bulkhead Replacement.We're getting down to the "little things" that won't mean much to most of you unless you have had some "nits" that you've always wanted... -
-
Prime example of AI slop above..... LOL. I think marine mechanic jobs are safe for now :)
-
jssailem replied to the thread Replacing the cutlass bearing on a 1996 Beneteau 351.No, just an intelligent build on part of CAL. Not all boat builders are the same. Some plan for the inevitable demands of active...
-
jssailem reacted to Ralph Johnstone's post in the thread Replacing the cutlass bearing on a 1996 Beneteau 351 with Ha.
I'll be bettin' that's the result of hitting that extre large rock at full speed last year :biggrin:. Shaft alignment to the strut...
-
Ralph Johnstone replied to the thread Replacing the cutlass bearing on a 1996 Beneteau 351.I'll be bettin' that's the result of hitting that extre large rock at full speed last year :biggrin:. Shaft alignment to the strut... -
-
Ralph Johnstone replied to the thread Replacing the cutlass bearing on a 1996 Beneteau 351.Holy crap :yikes: ! Jusy had a quick look at the the "strut pro tool". If I'm looking at the right tool, those things are bloody...
-
-
jssailem reacted to Ralph Johnstone's post in the thread New air filter completely clogged in under 20 hours!? with Like.
And so, @Project_Mayhem . What did you find ? General dirt and grime or V-belt dust ?
