All Activity
-
jaysweet replied to the thread Yanmar electrical problem..Dave, The start battery is maybe 5 years old. I intentionally used it instead of the house bank, because I wanted a weaker battery to... -
jssailem replied to the thread Time to get moving....Sounds like it was a great time.:beer: -
jaysweet replied to the thread Yanmar electrical problem..Greg, Thanks. I think all the testing wasn't really necessary, since this is a well documented problem. But it did get me in there...
-
Sorry to hear about your lost panel. But why was your battery empty? Was there a load on it while you were gone? -
Ddlochner replied to the thread Yanmar electrical problem..The voltage drops after cranking seem quite high. How old is the start battery? The resting voltage is fine however dropping to 10.2...
-
Sounds like you had a grand time! :beer: -
Tally Ho replied to the thread Yanmar electrical problem..Nice analysis. I have the same engine and same intermittent starting issues. I was going to reach out to Ralph Johnston to get some... -
IThe project progresses; thanks for all the photos, guidance and suggestions from your experience. The mast is down and the chainplates...
-
kappykaplan replied to the thread Time to get moving....Sounds like you had a grand time! :beer: -
BBrian M H23 replied to the thread Time to get moving....We made it!! Day two was a DAY, we started moving in the dark, bucked out Barnegat inlet at 630 in the morning, and with a fairly...
-
-
Hayden Watson reacted to Stu Jackson's post in the thread Engine went Kaput seven days into a three-week cruise. with
Like.
Hayden, when you get a moment, look at the link I posted. Not now, you're busy! :yikes:But it discusses details and has pictures that... -
jssailem replied to the thread Wiring Diagram for Lithium Ion installation.I used wire pin terminals https://www.mcmaster.com/products/wire-ends/pin-compression-lugs~~/ I’m going to add a wire clamp to fix the...
-
-
jaysweet replied to the thread Yanmar electrical problem..This is rather long, so please feel free to ignore if you're not interested. I’ve had a problem with starting my Yanmar 2GM20F for many...
-
-
Ralph Johnstone replied to the thread Keel stud chemistry.Place a magnet against it to see if it's SS or mild steel. -
smokey73 replied to the thread Wiring Diagram for Lithium Ion installation.Yea, I am overthinking it. I'll install it under the nav table where it is only about 5 feet from the new Li battery and install a wire...
