All Activity
-
shemandr reacted to Don S/V ILLusion's post in the thread H39 air conditioner supply vent(s) location with
Like.
The factory didn’t install A/C units, ducting or vents. It was typically all done at commissioning so there will b variability in... -
kloudie1 replied to the thread Force 10 Oven Problem - Oven control knob won’t turn.As jssalem says, the valve/igniter can be serviced somewhat. Most of those here in the USA are made by Robertshaw; Force 10 just buys... -
JamesG161 reacted to Don S/V ILLusion's post in the thread H39 air conditioner supply vent(s) location with
Helpful.
The factory didn’t install A/C units, ducting or vents. It was typically all done at commissioning so there will b variability in... -
JamesG161 replied to the thread H39 air conditioner supply vent(s) location.The Air mover fan has "vent" for warmer air, normally called "return air"" The Air is cooled through finned heat exchanger and pushed...
-
Don S/V ILLusion replied to the thread H39 air conditioner supply vent(s) location.The factory didn’t install A/C units, ducting or vents. It was typically all done at commissioning so there will b variability in... -
Adds a whole new meaning to the word "tacky". -
BigEasy reacted to jssailem's post in the thread Force 10 Oven Problem - Oven control knob won’t turn with Like.
I have a 3 burner F10. It can be taken apart and rebuilt. I was having a problem lighting the burners. Removed each burner. Cleaned... -
Joe replied to the thread Crack in Starboard Bulkhead Or Edge Joint?.What's that supposed to mean? Most bulkheads in production level sailboats are veneer over marine plywood. -
Joe replied to the thread Is this OK? Harbor noise..I like it! I want one.... owning a rig like that might inspire me to take up fishing and drinking French champagne. :) Then again... it...
-
Ddlochner replied to the thread Stony point NY.I've motored through there several times. If I recall correctly there are some shallow areas. Other than possible shallows the only...
-
Ddlochner replied to the thread How accurate does one have to be when measuring Gray Enterprises portlights for replacement?.The lens, the part of the port you see through is 14 ½" the extra is frame. I say this without having seen this particular port up close...
-
I have three questions; what’s the top speed, fuel burn rate, & fuel capacity? *My AI says 100GPH? 1000 gallon tank. Top speed 70mph...
-
https://youtube.com/shorts/lXfPOA8Sfbg PaulK, that’s a great start for a happy couple. Here’s a link to a typical Saturday/Sunday HCB...
-
Alan Gomes replied to the thread Sailing to the Kung Fu Island.Thanks for these details, Gary. Sounds like you really have to time your crossing well! -
jssailem replied to the thread Force 10 Oven Problem - Oven control knob won’t turn.I have a 3 burner F10. It can be taken apart and rebuilt. I was having a problem lighting the burners. Removed each burner. Cleaned...