All Activity
-
jssailem replied to the thread Water not flowing out of exhaust.Depending on your through hull, you may be able to run a rod down the center and dislodge the gunk. -
shemandr replied to the thread Adding turning blocks at mast base.It looks simple but can be a bit involved. It would be a benefit to lay out the path of the line led aft or even mock it up. You may... -
JoeWhite replied to the thread Diesel fuel can for boating.I wear gloves to keep my hands clean. -
john6206 replied to the thread Water not flowing out of exhaust.Thanks everyone, Engine is Westerbeke 30b 30 years old 957 hours After some troubleshooting, the intake is clogged. We opened the... -
Ddlochner replied to the thread Adding turning blocks at mast base.There will be a lot of vertical force on the block, so it would be best to mount it on the mast. Use a single block attached to the mast...
-
fred1diver replied to the thread Adding turning blocks at mast base.Ok the only picture I have is from the back of the mast, you kind of see the starboard side, all other pictures o have are from the dock... -
-
fred1diver replied to the thread Adding turning blocks at mast base.My halyards are external, the main is on the starboard side as it should be, I was looking near the base as you suggested, just not sure...
-
Bob S reacted to rgranger's post in the thread can you mix winch and winch handle brands? with
Like.
Unlike @dlochner , I have had a winch handle go overboard ...twice. Both times the jib sheet caught the handle during a tack... (I... -
JamesG161 reacted to Ralph Johnstone's post in the thread Water not flowing out of exhaust with Like.
What do you mean by "old impellor" ? Is this the one that is currently on the engine or an old one out of the junk box ? Answer my... -
Unless you have a very detailed plan to cover your experienced needs I do not see why there would be a need for 4 fans in a 22' boat...
-
Bob S replied to the thread Diesel fuel can for boating.I've used a shaker siphon, works great but my hands always end up smelling like diesel. The Surecan works great but a 5 gal can weighs a...
-
shemandr replied to the thread Adding turning blocks at mast base.I think I'd put it on the Starboard side of the mast near the base. If it's too high on the mast the lead to a turning block, winch or...
-
The simple method, for 5-gallon transfers, is a shaker siphon. You don't hold the can, no moving parts. Cheap and reliable. What I...
-
I've had a Surecan for ~ 5 years. No spills, not ever. It is the only can I use to fuel my boat. (Do place the nozzle in the tank...
-
Ralph Johnstone replied to the thread Water not flowing out of exhaust.What do you mean by "old impellor" ? Is this the one that is currently on the engine or an old one out of the junk box ? Answer my...
