All Activity
-
If you have a Y-valve, check to make sure it’s in the right position. You could also run a plumber’s snake down the pump out line to... -
No. This is a commonly held misconception. I've been in the tanker business, speced them out, and watched suction lines on spools fail...
-
jssailem replied to the thread SimRad WP30 Autopilot.Ok. You have a V-Belt guide and a V-Belt. You might be able to glue them. Worth an attempt. Not sure what to use. Perhaps contact... -
Joe replied to the thread Outboard Motor Mount question. Can't adjust the tilt on it?.Did you try loosening the Hinge bolt. That would be the non adjustable one on the other side of the plate. There appears to be another... -
Joe replied to the thread Spare dockline when you're away.When we have heavy winds expected in our area or I'm away from the marina for an extended period, I will DOUBLED the docklines rather...
-
Spare lines? I live my lines behind at the dock when I go sailing. They are tied to the dock cleats at the just the right length...
-
kloudie1 replied to the thread Mast foot ripped just about off H26.ooooohhh.. Torsion failure.. I think the cracks could be welded up since most of the sailing load is compression at the mast base.. then... -
BBenny17441 replied to the thread Spare dockline when you're away.Spare lines? I live my lines behind at the dock when I go sailing. They are tied to the dock cleats at the just the right length...
-
Davidasailor26 replied to the thread Mercury Very high revving at Very low throttle? (small outboard).If you could try it someplace under a real load that might give a better idea. If it’s revving because it’s too lean a load will... -
BBenny17441 replied to the thread Mast foot ripped just about off H26.Just make the mast shorter by cutting above the gash. Drill holes to re-rivet to the base. you will have to adjust the turnbuckles on...
-
For a friend: The boat has a Simrad WP30 unit and the electronics apparently work but it will not turn the wheel. What my question is... -
-
Gene Neill replied to the thread Large area hull deformation - Is this concerning?.I wouldn't worry either. I would IMMEDIATELY get some proper form-fitting bunks on that trailer, though. Yikes. -
-
kappykaplan replied to the thread Large area hull deformation - Is this concerning?.I believe you have a case of "canning" from being on the trailer for such a long time. My understanding is that it usually corrects... -
No. This is a commonly held misconception. I've been in the tanker business, speced them out, and watched suction lines on spools fail...
