All Activity
-
Recently was on my friend's Catalina 355, he had put the Y adapter on the stern so he only had to use one cord for his shore power. My... -
buddybear replied to the thread 310 primary anchor.I use a 33Lb Delta it fits well and has done a good job holding.
-
jssailem replied to the thread Overheat adventure on 1985 Universal M12.As you state, “It needs a proper ground from its threads to the exchanger” The threads provide that electrical link as the exchanger... -
jssailem replied to the thread Storage for portable gen set, Hunter 40.5.Your image showed a good looking hatch. Liked the piston helping to hold hatch in place.
-
Hi Jim, John I have no intention to run the gen set in the storage position, even if it is tempting and it could be organized with good...
-
You could also check with your local sail loft to have them made.
-
Same hatch on my 310, had local fabric shop make one from sunbrella with an elastic perimeter cord for about 20$ cdn. Fits nice and...
-
jssailem replied to the thread Request for instructions to wire 1997 Hunter 376 VDO Quartz hour meter to Yanmar 2JH3E.:plus: With @east coaster. That is the way I wired mine, after the engine rebuild.
-
jssailem reacted to east coaster's post in the thread Request for instructions to wire 1997 Hunter 376 VDO Quartz hour meter to Yanmar 2JH3E with
Helpful.
My old yanmar 2gm had the hour meter/tach power from a magnetic sensor on the flywheel housing. I would suggest one vdo lead go to... -
Adjust the tell tales using the jib cars, don't look at the wind indicator since it only describes the apparent wind angle at one... -
Eeast coaster replied to the thread Request for instructions to wire 1997 Hunter 376 VDO Quartz hour meter to Yanmar 2JH3E.My old yanmar 2gm had the hour meter/tach power from a magnetic sensor on the flywheel housing. I would suggest one vdo lead go to...
-
Eeast coaster replied to the thread Skylight covers?.Same hatch on my 310, had local fabric shop make one from sunbrella with an elastic perimeter cord for about 20$ cdn. Fits nice and...
-
sailme88 replied to the thread Overheat adventure on 1985 Universal M12.the anode is in place to be sacrificed to stray electric current. It needs a proper ground from its threads to the exchanger. As Richard... -
kappykaplan replied to the thread Skylight covers?.You could also check with your local sail loft to have them made. -
jssailem replied to the thread Skylight covers?.I purchased a cover for my Lewmar hatch from Amazon. Similar to this one. It eliminated the leak I had prior to installing the cover.
-
