All Activity
-
Oodaydokay replied to the thread Overheat adventure on 1985 Universal M12.Thank you very much. What’s the no-no on the Teflon tape?
-
Stu Jackson replied to the thread Do I want to purchase a 275?.https://www.sailplace.com/wp-content/uploads/2015/05/c375_specs2.jpg This boat has an unusual layout down below, with a large cockpit... -
Ccolemj replied to the thread Anyone use Yoga Mats for cockpit cushions?.On a previous boat, we used thicker closed cell pool floats. One was enough for the two cockpit benches. It was meant to be temporary...
-
LI managed to break the line that comes out of the bottom of the boom vang block and attaches to the mast step. It is a short piece with...
-
jssailem reacted to JamesG161's post in the thread Volvo Sail Drive sudden rapid galvanic attack damage and management question with
Like.
I hope all information supplied here, helps you with your issue. Jim... -
Rich Stidger reacted to Rick D's post in the thread Hunter Legend 40.5 fresh water tank leak with Like.
FYI, I have had my 40.5 for 27 years. The belly tanks will leak from the top cover and sometimes from the inspection port. This is... -
Our 1991 P42 came with an Onan 8W Genset using a Kubota three cylinder diesel. It can operate the two heat pumps, hot water heater...
-
jssailem replied to the thread Help with mast and vang attachment.Your vange as connected is not the OEM design. Explore this page on the Hunter site for a Vang Hinge. Attaches to the mast pin and...
-
-
ATru Fuel is all I use in my Honda 2.3 HP. Makes all the difference in performance. Once I mastered the half pull on the starting rope...
-
I would be concerned about that crack. I would think that could be welded to repair but you would need to find someone that does TIG...
-
JRacer replied to the thread Disassemble the trailer for storage?.Also, might consider a U-Store-It, self-storage place that has outdoor storage. -
JRacer replied to the thread Help with mast and vang attachment.I would be concerned about that crack. I would think that could be welded to repair but you would need to find someone that does TIG...
-
-
BBenny17441 replied to the thread Catalina 320 Engine Starting procedure.Suggest you adjust the sequence of selecting battery 1 to start the engine, to alternate selecting between battery 1 or 2 on subsequent...
-
Our 1991 P42 came with an Onan 8W Genset using a Kubota three cylinder diesel. It can operate the two heat pumps, hot water heater... -
JamesG161 replied to the thread Volvo Sail Drive sudden rapid galvanic attack damage and management question.I hope all information supplied here, helps you with your issue. Jim...
