All Activity
-
Dalliance reacted to jssailem's post in the thread New Owner // 1983 Hunter 27 // Running Rigging Questions with
Like.
Congrats on your new to you baot purchase. If your boat did not come with a manual, perhaps this link will help. Hunter_27_264067.pdf... -
Dalliance reacted to shemandr's post in the thread New Owner // 1983 Hunter 27 // Running Rigging Questions with Like.
Those are most likely the main and jib halyards. It is traditional to have the main on the Starboard side and the jib on the Port side...
-
Ddlochner replied to the thread Finishing Lithium Conversion on 450 Passage.The APM does nothing for the batteries, it protects the alternator in the event of a load disconnect on the alternator output. Load...
-
Ddlochner replied to the thread Finishing Lithium Conversion on 450 Passage.Get rid of them. Wire the alternator to the house bank and use a small DC-DC charger to keep the start battery charged. As for charging...
-
Ddlochner replied to the thread Boat Jack Stands.Cement blocks and 4x4s. Do this on a level surface. Disconnect the trailer from the tow vehicle. Lower the tongue to the ground and...
-
shemandr replied to the thread Boat Jack Stands.So you need the jack stands to hold the boat while you work on the trailer? You could rent stands from a local boat yard. During the... -
twodzusfittings replied to the thread Cabin top hand rail.Did you sand off the non skid before applying the Seadek? No, I cleaned it well, a final acetone wipe and then peeled the backing and... -
Davidasailor26 reacted to dLj's post in the thread Volvo Sail Drive sudden rapid galvanic attack damage and management question with Like.
Yeah, well at least he did try to make an explanation of how he's using an incorrect term. But there are so many red flags in that... -
Davidasailor26 reacted to dLj's post in the thread Volvo Sail Drive sudden rapid galvanic attack damage and management question with Like.
I really don't know why the marine industry - particularly the recreational marine market - refuses to use accepted terms and constantly...
-
Johann replied to the thread Finishing Lithium Conversion on 450 Passage.Since you are installing an externally regulated high output alternator you would typically connect the alternator to the LFP house bank... -
Ccolemj replied to the thread Volvo Sail Drive sudden rapid galvanic attack damage and management question.I have the same complaint, but at least this is the first time I've seen an author clarify how they were using the term "electrolysis"...
-
JoeWhite replied to the thread Overheat adventure on 1985 Universal M12.Remove the heat exchanger and clean it. I would think it would be a bog mess the way you are describing. Also your engine will ovetheat. -
Ccaptcoho reacted to kappykaplan's post in the thread Looking for plexiglass washboards for a Catalina 34 with Like.
Yes, indeed! :beer:
-
Ccaptcoho replied to the thread Looking for plexiglass washboards for a Catalina 34.I built a frame out of mahogany to accommodate the thickness of the original hatch-board and using it as template made a framed clear...
-
Oodaydokay replied to the thread Overheat adventure on 1985 Universal M12.I have one of the Mr. cool replacement heat exchangers, copper nickel. The good thing about these is that you can service both ends as...