All Activity
-
Ddlochner reacted to dLj's post in the thread Volvo Sail Drive sudden rapid galvanic attack damage and management question with
Helpful.
I really don't know why the marine industry - particularly the recreational marine market - refuses to use accepted terms and constantly... -
jssailem replied to the thread SCAD TM2 Sensor Not Detecting Tank Level on Plastic Holding Tank.For the externally attached SCAD sensor, each of these conditions could impact the ability of the sensor to function as desired. Even... -
Sounds like a trip to Port Townsend is in order.
-
kloudie1 reacted to thinwater's post in the thread Anyone use Yoga Mats for cockpit cushions? with
Like.
One-inch closed cell foam is best cut with a sharp razor knife. The "foam cutters" are for thicker foam and open cell foam. Sure, why... -
thinwater replied to the thread Anyone use Yoga Mats for cockpit cushions?.One-inch closed cell foam is best cut with a sharp razor knife. The "foam cutters" are for thicker foam and open cell foam. Sure, why... -
Ddlochner replied to the thread Anyone use Yoga Mats for cockpit cushions?.There are 2 basic types of foam, open cell and closed cell. Open cell foams are like sponges, the bubbles that form the foam are broken...
-
Ralph Johnstone replied to the thread i have just purchased a 83 hunter 34 and first item to address is the smile doesn' seem to awful but could use advice from othe owners. seal and fair.."The outcome of doing what" may I ask ? -
jssailem reacted to JamesG161's post in the thread Volvo Sail Drive sudden rapid galvanic attack damage and management question with Helpful.
I just found a good reference on this issue. _______ ____ Jim...
-
shemandr replied to the thread Do I want to purchase a 275?.If you are contemplating buying a boat remotely I think you need someone to look at the boat in person. Ideally that would be a... -
Yes, I used Laborde Power Products many years ago. They used to be the Yanmar distributor for Southern region. Not sure what their...
-
Hayden Watson replied to the thread What bottom paint for PNW....1.6 gal for 2 full coats -
jaysweet replied to the thread Yanmar gaskets, o-rings, etc..Thanks for all the replies. I also haven't had to buy many Yanmar-specific parts with this boat, because my 2GM20F has just worked... -
Terry Cox replied to the thread CAMPING FEES IN BC. BE AWARE!.No need to use mooring. I've anchored in here before. Good holding and plenty of room. -
shemandr replied to the thread Hunter 240 Rig Upgrades.I like the alterations #2 to 4! I don't completely understand #1. I guess it was necessary after the failure of the original setup...
-
Hayden Watson replied to the thread What bottom paint for PNW....My C30 takes a bit more than 1.5 gallons. I save the leftover paint and use it first on the next time painting. It lasts almost...