All Activity
-
I have been watching this thread closely due to the potential for it to turn overtly political. Thus far the content has remained... -
I apologize for starting this discussion thread here. My only intention was to raise awareness of tariffs on goods ordered from...
-
Big Easy probably remembers our local Yanmar parts place in Covington, La.. Laborde Power Equipment. They were great to deal with and... -
Try replacing the cord with Stihl’s Elastostart pull cord & handle. Many owners’ of Stihl‘s high compression chain saws report...
-
Ralph Johnstone replied to the thread What bottom paint for PNW....I find it surprising how many people keep coming forward to say that they are getting 4, 5, and six years from bottom paints while the... -
Ddlochner replied to the thread Yanmar gaskets, o-rings, etc..Well, @kloudie1 your comment inspired me to check with another Claude to see what my Yanmar 3JH2e is based on. Claude's response: "The...
-
kloudie1 replied to the thread Yanmar gaskets, o-rings, etc..Big Easy probably remembers our local Yanmar parts place in Covington, La.. Laborde Power Equipment. They were great to deal with and... -
BigEasy replied to the thread Yanmar gaskets, o-rings, etc..Couple of years ago, I attempted to order from Mack Boring, thru their online portal. Once I had entered my shipping address, I...
-
I wasn't aware that Yanmar had such territorial restrictions. Next time I run into anyone from Mack Boring, I'll ask about that...
-
Ddlochner replied to the thread Yanmar gaskets, o-rings, etc..To the best of my knowledge, Mack Boring does not sell retail, they are the Yanmar supplier. Niemic Marine is my go to shop for Yanmar...
-
BigEasy replied to the thread Yanmar gaskets, o-rings, etc..Last time I checked, approximately two years ago, Yanmar keeps tight reins on their parts distributors with regards to only allowing...
-
Rick Webb replied to the thread Aluminum or stainless, and type, on mast support pole, Hunter 23.5?.Raising the mast support pole will raise the end of the mast while trailering. I'd do some sort of setup where the additional piece is... -
jssailem replied to the thread What bottom paint for PNW....I too use Trinidad. Hard surface. Easy clean say my diver. I have been getting 5-6 years between paint jobs. Pettit makes an Odyssey... -
jssailem reacted to kappykaplan's post in the thread Corroded Dezincified Hose Barb on Raw Water Intake Ball Valve with
Helpful.
Here's the link (and it's @Maine Sail) ... -
Ralph Johnstone replied to the thread What bottom paint for PNW....I guess there's no pleasant memories there to rekindle. Best let sleeping dogs lie. All that aside, I would still very strongly...
-
