All Activity
-
Ddlochner replied to the thread Yanmar gaskets, o-rings, etc..To the best of my knowledge, Mack Boring does not sell retail, they are the Yanmar supplier. Niemic Marine is my go to shop for Yanmar...
-
BigEasy replied to the thread Yanmar gaskets, o-rings, etc..Last time I checked, approximately two years ago, Yanmar keeps tight reins on their parts distributors with regards to only allowing... -
Rick Webb replied to the thread Aluminum or stainless, and type, on mast support pole, Hunter 23.5?.Raising the mast support pole will raise the end of the mast while trailering. I'd do some sort of setup where the additional piece is... -
jssailem replied to the thread What bottom paint for PNW....I too use Trinidad. Hard surface. Easy clean say my diver. I have been getting 5-6 years between paint jobs. Pettit makes an Odyssey... -
jssailem reacted to kappykaplan's post in the thread Corroded Dezincified Hose Barb on Raw Water Intake Ball Valve with
Helpful.
Here's the link (and it's @Maine Sail) ... -
Ralph Johnstone replied to the thread What bottom paint for PNW....I guess there's no pleasant memories there to rekindle. Best let sleeping dogs lie. All that aside, I would still very strongly... -
-
Hello Below replied to the thread What bottom paint for PNW....Sounds like a trip to Port Townsend is in order. -
Davidasailor26 replied to the thread Yanmar gaskets, o-rings, etc..The marina we stay at is a Yanmar service shop. I’ve used them for belts, service kits, and that kind of thing. You’ll probably need to... -
Hayden Watson replied to the thread What bottom paint for PNW....I berth my boat in Oak Harbor Marina on Whidbey Island and use Petitt Trinidad. I put in on in 2005 when I brought my boat from Coeur... -
jssailem replied to the thread Furler Q’s.The trouble is the correct equipment on a boat is always expensive. It also works correctly for a good length of time.
-
All is resolved, we got a nice ($$$$$) rigging shackle to intall between the masthead and furler, everything is as it should now
-
fred1diver replied to the thread Furling line control.I didn’t need to Install a swivel, it had a retaining cap that I was able To remove after I took off the shackle, I did also add a block... -
fred1diver replied to the thread Furler Q’s.All is resolved, we got a nice ($$$$$) rigging shackle to intall between the masthead and furler, everything is as it should now
-
What's your best/favorite online source for Yanmar engine parts? In particular, I'm looking for the gaskets and o-rings used for a... -
heritage replied to the thread New Owner // 1983 Hunter 27 // Running Rigging Questions.https://hunter.sailboatowners.com/resources/index.php?task=model&mid=16. Lots of useful information in Hunter Owners Resources. Here...
