All Activity
-
shemandr replied to the thread Aft cleat for Jib Sheets?.Cam, jam, clam - I think there's confusion about each. I would agree with Stu's post if it were about jam cleats which I don't trust... -
Maine Sail replied to the thread Terminal connectors.This may help: Crimp Heat Shrink Terminals Like a Pro -
Perhaps on boats over 45’ in length, dual helms are an improvement in design & practicality. No way, no how, can I see a boat in the... -
I feel the same way about shift/throttle levers at shin height
-
Stu Jackson replied to the thread Aft cleat for Jib Sheets?.Clam cleats are notorious for intermittent holding. As such, they are a poor choice for this application. IIRC, my 1981 C22 #10496... -
Ddlochner replied to the thread Hunter 41DS prop shaft to gearbox key way falling out.As tight as you can get them!
-
BigEasy reacted to jssailem's post in the thread DIY Bowsprit Anchor Hanger made of ROPE? Danforth Anchor with
Like.
There is a bowline knot that has two loops. This might be a solution. The loops are adjustable after you have tied the knot. This might... -
jaysweet replied to the thread leak to bilge in head.I managed to find a leak recently by taping plastic over all the places nearby (on the outside of the boat) that I suspected, and... -
Ddlochner replied to the thread Fiberglass hull storm damage repairs.Morning update: This morning I sounded the hull at and near the abrasion damage, all the taps were sharp and clear, confirming my...
-
PPAC3142 replied to the thread Water tank access on 1993 Hunter Legend 35.5.The hatch in my picture is original. I've made new access hatches for the quarter berth in this boat and to access the hot water heater...
-
BigEasy reacted to jssailem's post in the thread Swap a Catalina mast for a 14.2 Capri mast with Like.
I would contact Dwyer Mast & Rigging. I suspect they would have the exact match. https://dwyermast.com/ If new is out of the budget...
-
BigEasy reacted to shemandr's post in the thread Swap a Catalina mast for a 14.2 Capri mast with Like.
Can't the OP find the original manufacturer or go to one of the remaining mast builders and have one made that fits the boat?
-
jssailem replied to the thread DIY Bowsprit Anchor Hanger made of ROPE? Danforth Anchor.On my 15ft boat, I would dip the anchor in the water or drag it behind the boat till the mud was gone. I found some clay off the bottom... -
jssailem reacted to Project_Mayhem's post in the thread DIY Bowsprit Anchor Hanger made of ROPE? Danforth Anchor with
Helpful.
How about a stiff brush and some water to clean the anchor? Wash down pumps are awesome but might be overkill for a C22 To hang the... -
jssailem reacted to kappykaplan's post in the thread Site not available from my Verizon Fios at home with Like.
Just got in after setting the Cloudflare app to Traffic only. Whoo hoo!