All Activity
-
Nothing too exciting here, but I'm nearly finished with fabricating and installing new Dyneema lifelines on Kolibri. 3 of 4 lifelines... -
JoeWhite replied to the thread Best 4 PIN thru-deck electric connection for mast?.https://www.westmarine.com/search?q=4+pin+deck+mounted+plug&lang=en_US&_gl=1*hbzs6y*_up*MQ..*_gs*MQ..&gclid=EAIaIQobChMI75D__5TdlAMVgCZEC...
-
-
Richard19068 replied to the thread Old 1973 Mercury Outboard (4hp) jumps out of water in REVERSE.https://www.ebay.com/itm/277812359415?msockid=06c4dbd6ca42699f3f7fccb0cb896852&_trkparms=amclksrc%3DITM%26aid%3D777008%26algo%3DPERSONAL... -
Ccolemj replied to the thread Anchor chain corroding after 2 years.This needs to be addressed separately. ACCO, Defender, and Budget Marine all stated this was hot dipped galvanized chain. It is not my...
-
Ccolemj replied to the thread Anchor chain corroding after 2 years.I don't think it is luck either, as any good chain should do that. Of the five chain replacements we have done over the past 17yrs...
-
Ccolemj replied to the thread Anchor chain corroding after 2 years.Since ACCO only produces hot dipped galvanized anchor chain, and the one industrial non-hot dipped galvanized chain they produce has...
-
Allan12210 replied to the thread Water line compression fitting search.I remember Ace Hardware used to stock the butyl parts as well. They were hanging on the rack at our local store. Is your issue that the... -
thinwater replied to the thread Anchor chain corroding after 2 years.I wonder if there are some odd cases of stray current and hyper-saline wet/dry chain at play, which can cause the galvanizing to fail... -
Allan12210 reacted to kloudie1's post in the thread Water line compression fitting search with
Like.
My H34 has poly butylene lines and fittings. The fittings are imperial and I had no issues finding stuff at Home Depot. It may be that... -
Allan12210 replied to the thread Hunter 41DS prop shaft to gearbox key way falling out.If you can tap it back in flush then install a stainless steel split collar on the shaft. Available from Amazon in the correct diameter...
-
Ideas for a hard top. https://www.epoxyworks.com/making-a-hard-top-for-an-h336-sailboat/ https://tartarooga.com/... -
Stu Jackson replied to the thread Hunter 41DS prop shaft to gearbox key way falling out.Putting aside the shaft scoring issue and dealing ONLY with the key: I actually found NO key once!!! I went and got another one...
-
Stu Jackson replied to the thread Can someone tell me whats going on with this old motor mount?.And for yet another skipper heard from, that'd be me :cool:, I always left the boat with the power switch OFF. There was nothing that I...
-
Ccolemj replied to the thread Anchor chain corroding after 2 years.If that is the case, then they were intentionally misrepresented as US produced hot dipped galvanized by ACCO, Defender, and Budget...
-
Davidasailor26 replied to the thread Can someone tell me whats going on with this old motor mount?.I think most people leave power at least to the panel, and just turn off most or all of the switches there when away. I know that’s how...
