All Activity
-
Paint will not adhere to an oxidized surface. If you opt to paint, it will be necessary to sand the gelcoat down past the oxidized... -
BigEasy replied to the thread Changing the faucet in the head of a 2007 Hunter 2007 - it won't budge..Limited access undoubtedly makes this task more difficult. Try to disconnect the water lines, then use a pipe wrench above counter top...
-
Ssenang replied to the thread Changing the faucet in the head of a 2007 Hunter 2007 - it won't budge..You get a lot of water infiltration at that spot
-
Ssenang replied to the thread Changing the faucet in the head of a 2007 Hunter 2007 - it won't budge..I only got it off by cutting it using a grinder
-
I bought one years ago . Very simple ,very durable and very loud . Rare that something like this works without an app ! -
Ddlochner replied to the thread To paint or not to paint.Paint will not adhere to an oxidized surface. If you opt to paint, it will be necessary to sand the gelcoat down past the oxidized...
-
There is only one best way to do this.... -
jssailem replied to the thread To paint or not to paint.I have a boat from 1973. The gel coat is oxidized. When I spray the deck it is difficult to tell where dirt ends and the rest is white...
-
Ddlochner replied to the thread OD 23-2 chain plate slipped/bulkhead soft. Patch or replace bulkhead?.Replace the bulkhead. To patch the bulkhead it would be necessary to cut out all of the rotting bulkhead and then scarf a new section of...
-
Don S/V ILLusion replied to the thread OD 23-2 chain plate slipped/bulkhead soft. Patch or replace bulkhead?.The consequence of a poor repair can be catastrophic. Removing the chainplate to inspect the condition of the bulkhead wood is the... -
Don Crowther replied to the thread Epoxy Paint.No painting company here. It's all DIY and any club members that you can convince to help. But everyone is in the same boat getting... -
patrickfarley replied to the thread Two hours AC.AC drains into the bilge -
Thanks for all the input. decided to use a combination of the methods and ideas given. Cut off the shackle at the old eye splice then...
-
patrickfarley replied to the thread Two hours AC.I still need to attach and install both parts with solar panels.
-
patrickfarley replied to the thread Two hours AC.AC installed and it works. It was 90 degrees and it pulled 540 watts but it cooled down to 80 degrees.
