All Activity
-
capta replied to the thread Light solutions for head.LED motion activated lights are what I'd go with today. 3M makes a double sided tape that will keep them on the wall forever, or use... -
Hello again all We are looking to replace the light in our head, just a wall mounted light, not very bright, my wife would like led stop... -
Hello all, I am looking to replace a gas vent hose, the new fitting has a ⅝ fitting, what type of hose do you all recommend? My...
-
Ralph Johnstone replied to the thread Raising a new main halyard.Just waaaaaay too simple for a one shot install. We can't argue about it, improve on it, change it or anything else. What good is that... -
I have successfully used gorilla tape over the butt joint - it holds so tight it is easier to just snip off the end than remove it.
-
I would confirm absolutely and with out a doubt that is the path the water is taking. The water we alway found in the galley on our H34... -
For all those that thought a six-pack was unattainable: -
kloudie1 replied to the thread 1985 Hunter 34 Deck Repair Help.I'm with Allan on this one. The toe rail is a design that wouldn't let water in except through the attaching bolts and those bolts are...
-
jssailem replied to the thread Deck question for 1985 Hunter 34.Here is a diagram of your basic dorade. -
-
jssailem replied to the thread Raising a new main halyard.Hayden. The whip secures both the buried cover and the core at the site of the whip?
-
kloudie1 replied to the thread Deck question for 1985 Hunter 34.The space under the sea hood is kinda like a big single dorade box for the ventilators. It separates rain or sea spray from the incoming...
-
-
My wife and I are both about 70 and we have a 1988 C30. We board the inflatable off the stern. What I do is lash the kink bow and...
-
jssailem replied to the thread Wednesday is Photo Day 2025.Yes. His presentation is a good one of the locking Brummel from a single end. I found this one as well.
-
BigEasy reacted to RKenSailor's post in the thread How to Reseal New Design Frameless Windows with
Like.
Finally warm enough to finish the window job this weekend. Adhesive needs 60+ degrees. I did not try debond, b/c I never ordered it, but... -
Not my pic, but it was my inspiration. We bought one of these last year. It's not quite Yeti quality, but it is head and shoulders above...
