All Activity
-
jssailem replied to the thread Refitting Hunter 40-1, need some advice....Welcome to SBO @qualityexteriors Share your thoughts and concerns here and the members will try to help with ideas and suggestions. -
jssailem reacted to kappykaplan's post in the thread LED light upgrade for 1988 Saber 34mkII with
Helpful.
Yes. I did so on my boat when the bow lights failed. -
CCapn Bill replied to the thread Boat access for Old Folks....
-
Ddlochner replied to the thread LED light upgrade for 1988 Saber 34mkII.Welcome to SBO. There is a lot of good information on SBO about boats in general, however, if you want to tap Sabre expertise the place...
-
The clutch on my new Lewmar VX1 has a special wrench for the clutch and I wanted it to have a dedicated storage location to keep it... -
Allan12210 replied to the thread 1985 Hunter 34 Deck Repair Help.I would confirm absolutely and with out a doubt that is the path the water is taking. The water we alway found in the galley on our H34... -
Don S/V ILLusion replied to the thread 1985 Hunter 34 Deck Repair Help.No one WANTs to remove _________________ [ fill in the blank] to fix a leak but there is no good alternative. -
kappykaplan replied to the thread Refitting Hunter 40-1, need some advice....qualityexteriors, welcome to the forum! :beer: The original poster (OP) hasn't been seen since Sep 2025. -
Let me know how it goes. I have the V3 on my boat. -
fred1diver replied to the thread 1985 Hunter 34 Deck Repair Help.Well unfortunately, if you want to be very water will not find a way in, the best is to remove it, sorry I know it is not what you want... -
kloudie1 reacted to jssailem's post in the thread LED light upgrade for 1988 Saber 34mkII with
Like.
Welcome to the SBO Forum. Two paths are possible. Simplist is to replace the light fixture with LED fixtures. It is a DIY project. More... -
Get a boat with an open stern if you plan to board from a dinghy, there is no better alternative. -
LakeOntario270 replied to the thread Raising a new main halyard.I just did this job. Put the two ends together and wrap a piece of electrical tape to hold them together. Then use a needle and some...
-
shemandr replied to the thread Raising a new main halyard.Connect the ends of the old and new halyard via a sewn whipping. It's an easy job but if you just use tape and the ends pull apart... -
Davidasailor26 replied to the thread LED light upgrade for 1988 Saber 34mkII.You can. The only tricky thing is that if you just replace the bulbs and not the whole fixtures for nav lights you might change the...