All Activity
-
Ddlochner replied to the thread What is the purpose of this plumbing setup? (3-way connection under the sink).It is a fairly common practice to route several drains through one through hull. In your case, I suspect there was an electric bilge...
-
Dalliance replied to the thread Fuel filter and sea strainer relocation?.My primary fuel filter was originally located in the engine compartment behind the engine. I moved it forward of the engine where it’s... -
jssailem replied to the thread resignation.One life chapter finishes, and a new chapter begins. Fair winds. Be not a stranger. Alan & Eileen -
jssailem replied to the thread New windlass for Papillon..You might consider installing an anchor counter. While not a perfect solution, I am guessing they could be accurate to within a couple...
-
I fully agree that you need to be at the bow to retrieve the anchor. In my case, I will need to handle the nylon rode into the aft...
-
I don't think a remote switch for the windlass at the helm is a very good idea. The anchor below was fouled in the chain about half way...
-
jssailem replied to the thread Hunter 336 gelcoat repair.Oh come now Ralph. You know you could appreciate Oyster Shell White.
-
jssailem reacted to CABixler's post in the thread Mast mounted plastic resin halyard cleat for jib replacement? with
Like.
Thanks to all!! I did find exact replacement at US Spars. Easy webpage to look up. Resin was $17 but Aluminum Anodized was $30 so went... -
jssailem replied to the thread Bottom Paint for Puget Sound.Hope you are successful. I have had a good experience with Trinidad in the waters of Port Everett. My diver likes it. Has made his job...
-
I fully agree that you need to be at the bow to retrieve the anchor. In my case, I will need to handle the nylon rode into the aft... -
Boat was put on the hard today for a full bottom job and strut replacement. I ordered the strut through the parts section on this...
-
BigEasy reacted to CABixler's post in the thread Mast mounted plastic resin halyard cleat for jib replacement? with Like.
Yep you were spot on. Mine was also US Spar. Easy to deal with. -
PAnyone out there know how the Morgan 34 mast step is engineered? Our sole has essentially rotted away around the step, which seems to be...
-
I fully agree that you need to be at the bow to retrieve the anchor. In my case, I will need to handle the nylon rode into the aft... -
Allan12210 replied to the thread UV Damage to Seadog Dorade Cowl Vents.Usually acetone takes care of that. I think it's just the plasticizer leaching out. Painting afterward seemed to control it later. The...