All Activity
-
JamesG161 replied to the thread In mast 'piece of crap' furling system.My guess is your sail has stretched and become "Baggy" along the Foot of the Sail Jim... PS: pictures might help us -
Maine Sail replied to the thread Acceptable methods for connecting three or more wires.Bingo! EE's are some of the worst DIY's, we worked with. It's like the minute they got out of school, and into their cube farm, they... -
AArt12050 replied to the thread Hunter Legend 310 - new potential owner.Regarding your Cutless Bearing; Yes, it can be an expensive job with the majority of the cost being labor. The actual parts are...
-
AArt12050 reacted to Ralph Johnstone's post in the thread Bottom paint - 2 coats or 3? Or even 4? 5? Why not 6? with
Like.
It has been stated too many times that "Location, Location, Location" is the controlling factor when dealing with each of the many... -
kappykaplan replied to the thread Nonsuch 26 rigging (cradle lines).I'll bet you wore them out good! :beer: -
Ddanm1 replied to the thread Boat access for Old Folks....https://stainlessoutfitters.com/products/marine/swim-platforms/ Personally, I bought a 2002 Hunter 356 which I think meets most of...
-
Ccolemj replied to the thread Acceptable methods for connecting three or more wires.LMAO! Forums like this are full of EE's saying things they are completely convinced are correct, while demanding people accept them...
-
Maine Sail replied to the thread Acceptable methods for connecting three or more wires.So, you've done the training, attended the standards meetings, voted on changes, passed the certification etc.? The standard is clear...
-
Side entry is safer to use, IMHO. the bow and stern will magnify any hobby horsing if you're anchored in choppy water. -
Stu Jackson replied to the thread Nonsuch 26 rigging (cradle lines).You're very welcome. Whenever I look on the internet for something the very LAST thing I ever do is post question on what, for boating...
-
Ralph Johnstone replied to the thread Bottom paint - 2 coats or 3? Or even 4? 5? Why not 6?.It has been stated too many times that "Location, Location, Location" is the controlling factor when dealing with each of the many... -
-
BigEasy reacted to Caboteur's post in the thread Mast mounted plastic resin halyard cleat for jib replacement? with Like.
Had the same problem, picked up a pair at a local Bénéteau dealer: they were a regular stock item. The sun & salt makes them brittle... -
Ddlochner replied to the thread 1989 Beneteau 35S5 Skeg dropped down on.The picture shows a strut. First step is to inspect inside the hull where the strut is anchored. Pictures of that area will help. In...
-
-
Caboteur replied to the thread Mast mounted plastic resin halyard cleat for jib replacement?.Had the same problem, picked up a pair at a local Bénéteau dealer: they were a regular stock item. The sun & salt makes them brittle... -
jssailem reacted to FastOlson's post in the thread 1989 Beneteau 35S5 Skeg dropped down on with
Helpful.
Pictured is the bronze casting that hold the cutlass bearing, which supports the shaft. That is not a "skeg". Alarming image , and a...
