All Activity

What's new Recent Activity New media New media comments All Activity
  • fred1diver
    fred1diver replied to the thread Shifter cable.
    Ok, I understand, what worries me is if you look at my pictures, where the sheath is badly damaged, the bend is pretty sharp, that is...
  • D
    dlochner replied to the thread Shifter cable.
    The radius of the bend is more important than the number of bends. The long routing may be to keep the bends more gentle. The other...
  • fred1diver
    fred1diver replied to the thread Shifter cable.
    Ok, thank you all for the great information When I looked at the cable when taking pictures, I found the cable routing seemed way more...
  • Terry Cox
    Terry Cox replied to the thread Cruising the BC Gulf Islands..
    JOHHHHNNNN. You forgot to mention one of our most favorite anchorages Annette Inlet!!!
  • Terry Cox
    Terry Cox replied to the thread Hunter 41DS New Owner.
    Welcome, Shannon, and congrats. We purchased our boat in Semiamoo, not Semiahoo. Blaine is nice, but we keep our boat in Shelter Bay...
  • Terry Cox
    Terry Cox replied to the thread Shifter cable.
    Not familiar with Pearson brand boats, but Hunter used Teleflex brand for their shifter and throttle control cables. At the pedestal...
  • Terry Cox
    Terry Cox replied to the thread Crack in paint along trailing edge of keel.
    Uncommon problem under normal operating conditions. It appears from your pics that some force caused the keel stub seal to break. If it...
  • jssailem
    jssailem reacted to colemj's post in the thread Shifter cable with Helpful Helpful.
    The manufacturer name may be on it, but many of the manufacturers have traded hands or stopped production, so going by that isn't always...
  • D
    dlochner replied to the thread Timing/order for waxing topsides when bottom painting.
    I've been using the Collinite products for years and have not had any issues with paint not adhering to the hull. Don't intentionally...
    • 1778034165042.jpeg
  • D
    dlochner replied to the thread Rustoleum Topside Polish?.
    Many waxes and polishes have an abrasive embedded in them. These will dull the finish. Compared to one part polyurethane and two part...
  • D
    dlochner replied to the thread Shifter cable.
    When you run the cables watch out for the bend radius, the cable will bind up if the radius is too small. Also watch out for chafe on...
  • D
    dlochner reacted to colemj's post in the thread Shifter cable with Helpful Helpful.
    The manufacturer name may be on it, but many of the manufacturers have traded hands or stopped production, so going by that isn't always...
  • jssailem
    jssailem reacted to Hello Below's post in the thread Cruising the BC Gulf Islands. with Helpful Helpful.
    Clean Marine BC
  • quadrille38
    quadrille38 replied to the thread Timing/order for waxing topsides when bottom painting.
    I usually wash and polish first because the cleaner I use will run down onto and make a mess of the fresh paint. Then I tape the paint...
  • D
    dlochner replied to the thread Pre-launch diesel maintenance questions.
    If the anode is zinc and it is in freshwater it will last forever and while doing so it will offer no protection. In freshwater aluminum...
Show older items
Top Bottom